14 models
The Benriner kitchen slicer is a staple kitchen tool, being much cheaper than the European brands of mandoline. I love mine. The julienne slicer / comb style blades are excellent, but they tend to get lost on the bottom of the drawer, and…
Print approx. €2.23–€2.73 excl. taxPreliminary estimate for one variant
This is a blade guard for the Super Benriner's No95 Mandoline, so that it's a bit safer to handle while not in use. It isn't horribly difficult to print, but you may need to keep the layer height <0.2mm for better layer adhesion around…
Storage box for Benriner mandoline utility blades. Category: Kitchen & Dining
This is a holder for Börner (Borner) V3 mandoline slicer and its accessories. It securely holds the main plate (held in place using integrated spring lock) with slice insert plate installed, two julienne insert plates (3.5 and 7 mm) and…
I created a cover for my Benriner mandoline to allow me to keep it safely in drawers without worrying about cutting my fingers. It worked so well I thought I'd share it. It also has storage for the three julienne blades that came with it.…
This unit secures to the mandoline’s main cutting blade using two rare earth magnets. The magnets can be attached using epoxy (or another suitable adhesive). The magnet diameter is 0.25” (6.35mm) and can be changed using the FreeCAD…
Updated Blade cover for Super Benriner No.95 Mandoline by yyy (@yyy_328830) to fit the Super Benrine No.64 Mandoline.
A holder for the blades of the "modern house basis mandoline": e.g. https://www.kitchn.no/nettbutikk/kjokkenutstyr/kjokkenredskaper/46180043/ it works, but it was a quick design and print. so roundings do not fit totally those of the…
I love my Benriner Mandoline slicer but the thickness selection screw rusted out after one too many trips through the dishwasher. These spacers clip right on the back side under the height-adjustable section and do the same job.
A simple holder for the Super Benriner Mandoline No.95, that you can screw to a Wall or the underside of a Board. I printed the part, in the Horizontal position, to give the whole Part more strength. I would suggest a Layer Hight of 0.2mm…
This is a print to safely store your mandoline upright on a shelf or against a wall. This fits the Bron Coucke classic 15000 model. Current version is a compact version, where the stand folds over the front. If there is interest I'll…
A story as old as time, you own a tool and it's parts are shipped in a useless plastic sleeve. Years go by and you keep sticking them back in the sleeve, but you get poked, the sleeve deteriorates, you slowly go insane. Then you wake up…
