Counting matching models…
This is a kit I designed that converts the Nerf Maverick into a Talon magazine compatible flywheel blaster that I have dubbed the “Mayfly”. It was inspired by an illustration done by the visionary Hotkoin, which you can see here: /…
This is a remix of the flywheel cage for the Mayfly by Gemeneye, to have the proper crush/spacing (19.5mm) for Worker Nightingale flywheels. You can use this with Honeybadger or Loki motors, or other similar high RPM motors. I've been…
Very fine detail- - you will need to scale this up a tiny bit if you want full detail WITH 0.2MM nozzle. You will need to scale this up a good bit more for full detail with 0.4mm nozzle. I used adhesion- might work without. Took about…
This is a version of @Gemeneye_212233's Slide Replacement/Stock Attachment for the Mayfly (Nerf Maverick flywheel conversion) with Fidlock stud attachment locations on the left hand side of the slide. The studs are 60mm apart, and it is…
Its the slide for the mayfly with Picatinny replacing the nerf rail, that is all!
Cosmetic mod which splits the cylinder into two pieces to allow you to print the front in a different color and get closer to the original Maverick look. Disclaimer that this is not airtight and would let water in (but who's running a…
I needed a way to attached Bruce Leedle's mega master-key to my newly assembled/built Mayfly. This (no hardware) clip on picatinny will work on a stock Maverick or a Mayfly. To help fitment and remove any rattle I added a .5" strip of…
This is the second version of the rev trigger for the nerf mayfly conversion, as you can see this version is a more traditional rev trigger that is more inline with the stryfe you will need to do a bit more plastic removal than my…
This is a Rev Trigger for the Maverick Fly wheel conversion “The Mayfly”. Was asked to post this model so here it is, print at whatever settings the filament you have is best at. You will have to cut a hole where the lever roller is at in…
The mayfly spring door failed me for the last time, so i made a slight redesign so you can add a heat set insert to the right side of the battery door. allows the use of a thumb screw which is IMO more reliable. you need these to make it:…
I needed a way to attached Bruce Leedle's mega master-key to my newly assembled/built Mayfly. This (no hardware) clip on picatinny will work on a stock Maverick or a Mayfly. To help fitment and remove any rattle I added a .5" strip of…
