Counting matching models…
Inspired by a model I bought but which I was not happy with, as it required a ton of supports and could only rotate, not tilt. This model can tilt up and down and rotate. The tilt automatically locks in the up position and a small plunger…
A clip-in enclosure for the Matek mR900-30-TX or mR-24-TX. If you are using these as a dedicated SiK telemetry replacement using USB serial connection, you can use this mount to protect the rear of the PCB and mount your mdem somewhere…
Print as oriented with no supports. Board will slide in. Small dab of hot glue can be used to retain if loose.
a vehicle recently introduced to Warthunder in a new update, my best attempt at a recreation of it.
A very simple print - the reciever slides snugly inside, the ufl is slightly pressed from top so the antenna sits solid. Also a small cutout to access soldering points from the bottom if somebody needs it this way. Small cutout for USB-C.…
This is the American MGM-140A (M39) Block 1, a High-Explosive ( HE ), single-stage, Solid-Propellant ( SP ), carrier, Inertial-Navigation-System ( INS ) guided Surface-to-Surface-Missile ( SSM ) used to dispense 950 x M74 submunitions…
Case for Ebyte E77-400MBL-01 and E77-900MBL-01 boards - only tested with the -400 version but they should share a footprint. Integrated SMA mount for an external antenna, micro USB port access and GPIO header access in the lid. Lid…
This is a complementary cover for the Matek MLRS Tx to be used with a TBS Lite/Nano rear part. Could probably easily be fitted to other Nano/Lite intefaces but I had a few spare ones for TBS crossfire so that's what I used. :) Printed…
This uses a Matek mLRS receiver module (mR900-30) with transmitter firmware installed and an ESP8266 (ESP-01) to serve as a backpack. Photos show it connected to a Radiomaster AX12. I've tested it but not long enough to get hot yet. It…
