16 models
This custom-designed enclosure is tailored to house the Plantower PMS5003 Air Quality Sensor, along with an ESP32 NodeMCU and a DHT22 (or BME280 when using the alternative lid included in the files) temperature and humidity sensor…
What is this? This is an enclosure designed to house an ESP32 board (specifically, an ESP32 DevKit V1 board), a PMS5003 sensor, and a DHT22 temperature/humidity sensor. It's powered through the ESP32's micro USB port, which is exposed on…
I needed an enclosure for the the PMS5003 Particle sensor that would meet my needs: slanted roof so rain/moisture rolls off mesh covered inlets to prevent critters from making a home inside anchor points for screwing into a pole / wall…
Box with lid for my PM2.5 monitor with PMS5003 and D1 mini pro
About Designed for environmental monitoring, Enviro+ for Raspberry Pi lets you measure air quality (pollutant gases and particulates), temperature, pressure, humidity, light, and noise level. When combined with a particulate matter…
Used Hot Glue to keep components in place
This is a case for A pico enviro+ with a PMS5003. it takes four 3mm heat inserts and M2 x 3mm Full Thread Cap Head Screws and two wall screws to fix it to a wall.
Remix of rainbow_wheez3's outdoor enclosure for the Plantower PMS5003 Particle Matter Sensor https://www.thingiverse.com/thing:4581351 I wanted a bit more wiggle room for the WeMos D1 Mini control board and cables. This is part of my…
hallo, habe diese minimalistischen Sturzbads für meine s51 u s53 entwickelt und würde sie gerne teilen, ich habe leider keine Bilder aber es passt super. Sollte mit min 40% gedruckt werden und max 75% da sonst das plastik nicht mehr…
Use WEMOS clone ESP32 D1 mini to control PMS5003 and BME680 sensors. Both are included in Tasmota all sensors. 2 cases included: one WEMOS ESP32 and with both sensors and one with WEMOS ESP32 and BME680 only.
This is the 3D-printed case from my build of a local PM1.0/PM2.5/PM10 air-quality sensor that reports straight into Home Assistant via ESPHome – no cloud, no app. What fits inside: - ESP32 DevKit - Plantower PMS5003T (particulate matter +…
Printet in PETG, 100% infill, 0.2 layers and supports everywhere.
A case for the Pimoroni Pico Enviro+ and PMS5003 particle size sensor along with an additional space for more sensors such as the SGP-30 sensor also sold by Pimoroni, as it is designed with inserts you can create your own plate for the…
Case for DIY project Air Quality Sensor ESP32C3+PMS5003
hallo, habe diese minimalistischen Sturzbads für meine s51 u s53 entwickelt und würde sie gerne teilen, ich habe leider keine Bilder aber es passt super. Sollte mit min 40% gedruckt werden und max 75% da sonst das plastik nicht mehr…
This is a case for A pico enviro+ with a PMS5003. it takes four 3mm heat inserts and M2 x 3mm Full Thread Cap Head Screws and two wall screws to fix it to a wall.
