Pico Enviro+ with PMS5003 and additional sensors and battery
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A case for the Pimoroni Pico Enviro+ and PMS5003 particle size sensor along with an additional space for more sensors
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 11
- Makes
- 0
- Views
- 198
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A case for the Pimoroni Pico Enviro+ and PMS5003 particle size sensor along with an additional space for more sensors such as the SGP-30 sensor also sold by Pimoroni, as it is designed with inserts you can create your own plate for the sensors you require keeping it somewhat universal.
Doesn't need fasteners (some glue may be required to hold the enviro+ in place as well as the sensor plate however glue is applied to the ends of the bar meaning you dont actually glue the enviro+ or sensor plate keeping it easily removable and swappable.
Qwiic and PMS5003 port remain usable with this design as well as keeping access to the USB port and button (tested with the “LiPo SHIM for Pico”)
- 1 x Main
- 1 x Backplate (Perforated or Solid)
- 1 x Battery-plate
- 1 x Insert (31.5 x 61.5 x 2mm) (Included is an insert for the SGP30)
- 4 x Retainer-Stick
- Some foam (if you want to add some padding to your battery to support it)
List of electronics used:
- Raspberry Pi Pico 2W (W not needed unless you want to use MQTT)
- Pimoroni Pico Enviro+
- Plantower PMS5003 with cable
- Pimoroni LiPo SHIM for Pico
- Pimoroni SGP30 Breakout
- PKCell 8800 mAh Lithium ion battery
- Qwiic/STEMMA QT cable (you may need one with DuPont or bare wire on the end to connect to sensors if they dont have a Qwiic port)
Order of operations:
- Insert your Enviro+ with the PMS and Qwiic connector plugged in where the USB port is facing the hole
- Insert your sensor module plate into the slot next to the Enviro+
- Place your PMS5003 in the upper slot with the fan in the larger cut out, route the cable around the edge
- Use the retainers to lock the Enviro+ and sensor plate in place on the edges, applying a small amount of glue on both flat ends of the stick, place either side of the modules
- Install the battery plate you may need to use glue here also but not necessarily
- [Optional] install some foam padding on the walls around the battery plate
- Place the battery
- Install the backplate of choice
Still a work in progress at the moment but is usable