Counting matching models…
0.2mm layer height Black PLA Print 2 clips To Install: -insert lower piece into upper piece from the top -extend telescope -place shroud inside telescope body -lower telescope aligning eye piece cut out -attach clips by placing over top…
This print will hold the three eyepieces that come with the OneSky telescope. Try printing it in glow-in-the-dark! The holes in the hinges have been sized to fit a short piece of filament, so are no additional parts needed to complete the…
The AWB OneSky telescope was not designed for solar viewing - make sure you know what you are doing if you attempt this! Instructions: Print 1 of each part and assemble as shown in the video. All the .3mf files are already oriented…
A 3-piece shroud to block out light for the OneSky's truss-tube design. Assuming your printer is calibrated, the pieces should slide easily against each other (parts have a 0.4mm gap), though depending on your telescope's tolerances,…
This is designed specifically for the Astronomers without Borders OneSky telescope . The ring gear is split into 3 pieces that fit very snugly, might require a touch of sanding. The snug fit and shaping around the upright means only one…
