Counting matching models…
Cheap webcam implementation to AD5M Flashforge sells camera kit, but it's kinda expensive in here, so i wanted to go to cheaper route. You need: (Maybe) Klippered AD5M - Haven't tested with the original firmware so it might work or it…
2 cases for the OV3660 3MP camera board/module with the small lens. Probably fits other board of the same form factor but I can't guarantee as I only have the ov3660. Minimal case is as small as possible and only includes a hole for the…
This is a simple mount for the OV3660 USB webcam on the Voron v0. The mount is designed to fit in the front left corner; you can mirror it if you want to place your camera on the right instead. Required hardware is: M2x6 screws and nuts…
a case for camera OV3660 and ender 3 s1 bed mount
Simple and functional two part housing for OV3660 type cameras. The housing front / main body comes in two variants. One with the arm mount on the side, one with the mount at the bottom. If you need the mount on the other side you can…
There are already two available camera mounts on printables that fit OV3660, but I was not able to user either one of them https://www.printables.com/model/703993-voron-0-usb-camera-mount Great mount, but unfortnutely I bought a 110 fov…
Put together with m3 plastic nuts and 8mm m3 screws. Supports needed.
OV3660 camera mount for ikea lack enclosure
This mount is been used for mounting a OV3660 110° Rectangular camera module (https://www.amazon.it/gp/product/B088P1PKFM) to a panel of my homemade enclosure using four magnets (Two inside and two outside) to have it easy to remove. File…
OV3660 Camera Mount for Ender 3 Pro, remixed one part and combined to another model
A minimalistic mount OV3660 on an aluminum extrusion. I designed this to mount on Voron 2.4's Gantry so I made it as compact as possible as it's going to share space with multiple accessories. Use M4x20 screw Get camera casing parts from…
A simple mount for a OV3660 on the Voron Switchwire
ESP32-CAM Lens Adjusting Tools for OV3660 These tools are for breaking the lens factory glue seal and also adjusting the lens focus. The ESP32-CAM lens comes glued in place from the factory. I found it very hard to break the glue bond…
Print with ABS or ASA, no supports needed. Split camera holder to have separate top cover. Run your camera wire in an inner side slot of the front left profile. No disassembly, just push the cable under the tensioner. I use original…
Popup wall mount for the following ESP32 Camera - https://www.amazon.com/dp/B0H2TT5MRG?ref=ppx_yo2ov_dt_b_fed_asin_title Intended for use with ESPHome, setting up spot watcher cameras for use within Home Assistant. Screws or Magnet…
Print with ABS or ASA, no supports needed. Split camera holder to have separate top cover. Run your camera wire in an inner side slot of the front left profile. No disassembly, just push the cable under the tensioner. I use original…
2 cases for the OV3660 3MP camera board/module with the small lens. Probably fits other board of the same form factor but I can't guarantee as I only have the ov3660. Minimal case is as small as possible and only includes a hole for the…
