Counting matching models…
DC and USB A Cable Passthru with TPU grommet and 2.1x5.5mm dc power inlet insert for honeycomb ams riser v3, should be compatible with earlier revisions too. Grommet files should be printed with TPU. Both should be friction fit, I have…
Having printed and installed the parts from Athlon to get both the E3d Revo Micro and Sherpa Mini direct drive installed on my Mini, I found 2 problems: 1: The sherpa filament entry point was loose on capricorn bowden tube (was fine with…
This is a PTFE passthru for the 8T INDX and the onetop combo. the origional design had all 8 tubes going thru the middle and that made it very hard to get them the right length and limited the options for mounting the filament sensors. I…
This is a component part of a 3D Printer enclosure project Print Settings Printer: Prusa I3 MK3S Rafts: No Supports: No Infill: 100 Filament: Prusament Orange + Prusament Galaxy Black PETG Category: 3D Printer Accessories
Print two of these to pass 4" ducting (Like the AC Infinity 4" ducting I used) through an enclosure wall for a 3D printer, laser etcher, etc… There are grooves to put adhesive foam tape in for a better seal; the foam tape stands slightly…
I wanted the option to pass a cable out of a closed case. This model fits a 33mm hole and has a 27mm ID. The model includes two nut versions (hex & star) and a screw on cap to seal the case when a pass thru is not needed. The body is 33mm…
A passthrough for a case, panel, or bulkhead with a screw cap and is slotted so the cap can provide a degree of weather protection while a cable is in place. The body has a 27mm ID. The model uses a nominal M33x2 thread. The model…
in the winter or better christmas time we are installing different stuff as decoration. sometimes we need some power cable to go from the inside of the house to the outside. in the basement i installed some window made of acrylic glass…
Created this because I wanted a better pass thru for my window that didn't involve tape to seal the gap or introduce more connectors and I wanted the cable to be protected from the weight of the window. I also knew that I could be adding…
Added a 1" boss to this model to allow for an Ecowitt weather station to be mounted onto a T-post. Weather station, for reference: HP2564 Wittboy Pro 7 https://shop.ecowitt.com/en-ca/products/wittboy-pro
in the winter or better christmas time we are installing different stuff as decoration. sometimes we need some power cable to go from the inside of the house to the outside. in the basement i installed some window made of acrylic glass…
This is a tool to hold a Magride strut on a C8 Corvette. This holds the top of the strut while you loosen the 17mm hex nut on the strut. Has a pass thru to allow for the Wires and a 14mm hex to hold. It mates with the 8.8 square D on the…
This will allow you to print via reverse-Bowden without taking the filament out of the drybox. Mounting is done via three M3 socket-head cap screws and hex nuts. The length of the screws will depend on your container wall thickness with…
I first used the 5mm connector wich came with the enclosure. But often the filament jammed in there, if not cut perfect or if it was a little bend. The 10mm connecters allow the tube to pass thru, so i modified the guide with a 10mm…
