Counting matching models…
I updated the model with a shorter base for an excellent hand grip. Handle added as well. There are no particular recommendations: printed in PLA, 15% infill, and three perimeters. The grinder inner stand profile isn't accurate and has a…
Εργασία για το Μάθημα «ΜΙΚΤΗ ΠΡΑΓΜΑΤΙΚΟΤΗΤΑ ΚΑΙ ΗΛΕΚΤΡΟΝΙΚΟΣ ΠΟΛΙΤΙΣΜΟΣ» ΠΜΣ "Ψηφιακός Πολιτισμός" ΠΑ.ΠΕΙ
The Pietro Grinder is famous for the great cups that it can produce but poor ergonomics. This base improves a lot the ergonomics: I'm not bumping my thumb on the table or the lever on my other hand; with a wider base, I put less effort…
Disclaimer: The base is designed to have a tight yet removable fit to the catch cup. Repeated installation and removal of the base may scratch the paint on the catch cup. Features: Designed from a trace of the catch cup geometry. Top lip…
Update: This project is now done. If you want to see any improvements, write them down so we can plan V2 together. Warning: This is not a simple project, so I would not recommend committing unless you are experienced in 3D printing and…
I found this very useful for the initial seasoning of the grinder. I will probably use it occasionally for espresso. With my drill it was loud and inelegant. It did not cause any wear on my brand new grinder. 1/4 inch sq driver version…
Pietro Grinder Cup Funnel 58mm for Filter and Espresso I made this funnel to make it easier to throw grinded coffee from a Pietro cup into V60. But then I decided to adopt funnel size to 58mm basket. So now it helps in both cases: for…
I managed to improve the taste on my Pietro grinder. The most convenient setup is to 3D print the stand and the extended handle. As always, I use my elbow. I’m not afraid to lean on it with my full body weight and grind the beans. It…
This model is an adapter for a HomematicIP ES-GAS-2 sensor; it allows the sensor unit to be easily mounted onto a Pietro Fiorentini gas meter. The adapter should hold securely even without a screw. A 5mm hole for a screw or similar…
Pietro, the holder created for Nintendo Switch, little notebooks and everything that can fit in it.
come riempimento consiglio di mettere tra il 10 e il 25% come altezza layer ho impostato 0,18 per avere un po più di definizione e velocità media.
Busto da rilievo fotografico con Autodesk ReCap. In memoria dell'ultimo vero urbanista e progettista di Sanremo. Realizzato da [email protected]
I updated the model with a shorter base for an excellent hand grip. Handle added as well. There are no particular recommendations: printed in PLA, 15% infill, and three perimeters. The grinder inner stand profile isn't accurate and has a…
