Counting matching models…
Designed by Blue Robotics, and used in previous BlueROV2 iterations. These parts allow a Pixhawk and a Raspberry Pi to be mounted together against a flat surface. Usage Example . Print in PETG.
Designed Foldable Tricopter for Pixhawk flight controller with HD camera gimbal 20x20mm square CF tubes from Hobby King T-Motor 2216 800KV motors X PDI-2506MG 25g Metal Gear Micro Digital Servo for RC Helicopter from Banggood Top and…
Why print this? I was previously using AliExpress folding GPS metal mount but I found out that it was oscillating. I also noticed that the double sided tape went loose after a few flights. My design is rigid enough to prevent oscillation…
Plate for gluing the PixHawk 5x/6x flight controller on the Tarot 650 Sport frame. The plate is attached to the original frame bolts.
a 3D printed TPU Pitot tube mount for a REMOVE BEFORE FLIGHT tag. I made this for my RC VTOL using Arduplane 4.3 Enjoy !, Dave
Rear shelf for Volantex Ranger 1600/2000. Accommodates Pixhawk in the "tub", with 2mm space on each side and bottom for some vibration dampening material. Rear opening is for servo cables and 2 cut-outs are for straps. Bellow the tub is…
This is a Pixhawk Cube (2.1) mount for a F550 Clone. The bolt holes are 3mm to affix the mount to the frame and the standard 2.5mm for the Pixhawk Carrier board itself. I have also included the washers I used in the files as well as the…
This safety switch holder can be installed on any one arm of the S500 or S550 quadrotor frame. It works with the screws
Pixhawk 6C Mini doesn't have a traditional 30.5 x 30.5 mm flight stack mount, instead opting for a zip-tie or adhesive-based mounting, with the recommendation of mounting a flat plate above your stack, and fixing the controller on top…
Printed from PLA What do you need? Four M2 5mm long screws
I'm mounting a Pixhawk GPS + compass unit (entirely for the compass) on the edge of a ROV frame, and needed a shelf to adhere it to. Maybe someone else has the same need. this assumes a 5mm shelf, but it should work for a variety of uses.…
Made a simple DIN-35 mount for Pixhawk 2 with simple holes to mount the pixhawk.
Initial design is for M2 screws, can be quickly modified if needed. No special print instructions.
In PLA. Print 15% infill with support on the build plate and organic supports. .20 balanced or structural. In PC Blend. Print 15% infill with support on the build plate and organic supports. .20 structural. Brace and Lock - Keeps the arms…
If you've ever built a Pixhawk-based UAV, you know how quickly wiring can become one of the most frustrating parts of the project. More boards, more cables, more connectors—and every addition makes assembly, troubleshooting, and…
Why print this? I was previously using AliExpress folding GPS metal mount but I found out that it was oscillating. I also noticed that the double sided tape went loose after a few flights. My design is rigid enough to prevent oscillation…
In PLA. Print 15% infill with support on the build plate and organic supports. .20 balanced or structural. In PC Blend. Print 15% infill with support on the build plate and organic supports. .20 structural. Brace and Lock - Keeps the arms…
