Counting matching models…
I had a mishap when I went to replace the antenna on my Meteor65 pro 2022 version whoop. So I had to replace the VTx, and decided to use a unify pro32 nano. Here's the mount I made for it. It works much better than what I did before……
Includes: Rear Hatch with a slot for the TBS Unify Pro32 HV and an MMCX 90 degree Antenna, such as the Foxeer Lollipop 20x20 M3 glue- (or velcro-)on stack mount (I use a Matek H743-mini V3) 14mm camera canopy (tested with the Caddx Ant)…
Weighs 0.26g Printed at ultra detail took 7mins. Added a tab to heat shrink the VTX's antenna to. I glued the edges of the TBS Unify PRO32 nano VTX to the frame with e6000 and let it dry over night. Pictured is the frame next to the…
Works for any 25x25mm stack. Print with well dried TPU with 100% infil. The bracket helps keeping the antenna in place, consider connecting it prior to inserting the affair in the bracket.
I didn't want to order seperate 25mm M2 screws + extra spacers to place the new TBS mounting board ontop of the stack so I created a custom mounting plate which replaces the one for the stock Runcam VTX on my Diatone GT-R349. I used 4mm…
TBS Unify Pro32 DP or HV VTX mount designed to fit in front of the Heewing T1 ranger. My goal was to have the antenna in line with the borders of the front air inlet. You need to cut out the foam inside the air inlet to get a better air…
A simple case to mount the TBS Unify Pro32 HV flush with the Wing surface. I used it to mount the VTX in a Mini Talon wing but other Wings would work too. The lid has a little cutout so that a little heatsink can get in the direct airflow…
VTX and TBS antenna mount for the astrox johnnyfpv v2 frame. I designed this because the new TBS vtx pro32 was just too big to fit laying flat. Recommended parts: TBS pro32 VTX TBS antenna w/ 90 degree Right angle MMCX Category: R/C…
TBS Pro32 HV mount for slammed Xilo Phreakstyle. Category: R/C Vehicles
