9 models
Optional upgrade for your RepRack or RepBox storage systems. Add a flange rollers to your slip rod setup for enhanced rolling as needed. Print directly from your RepRack or use in a standalone configuration. Snap fits cleanly over slip…
Modified RackRoller for RepRack that uses threaded inserts and M3 screws. Also added was mount for 4mm reverse bowen tube Didn't have the threaded forming screws so I made this which uses the same threaded inserts used in the Voron…
I wanted rollers where the bearings were a bit wider apart as I had a spool pull off when they're closer together, also doubled them up for spools next to each other on the RepRack to feed the Palette. I used 8x20mm metal pins (Amazon aff…
This is a filament runout sensor mount for RackRoller & Creality K1. I extended the filament sensor runout leads and attached the filament runout sensor directly to the RackRoller that's directly above my K1. This makes it much easier to…
If you're like me, I move my spools along my RepRack all the time so I never set the set-screws on my RackRollers… But as a result, my RackRollers tend to fall off my RepRack 😠 So I made these clips/locks, of-sort, to keep the RackRoller…
This model allows to properly space the RackRollers for most spool widths as well as serve as filament guide. You will need is a piece of PTFE tube which just fits through the center hole and is held by friction. The model is designed to…
This is a PTFE Tube Holder for the RackRoller by Repkord . Bill of Materials 1x PC4-M10 pneumatic fitting Options Crossmembers For Linking together Rollers: You have to print a 3rd 7mm diam crossmember or you can use something else. I use…
An easy redesign to add a holder for the 2 tubes for the rackroller.
I installed the Reprack and RepRackXL in my closet and needed the roller for the XL. I'm still learning how to use Fusion360, so this was a copy. I'm sure there was a better way to do this. This was printed on a modded K1 Max with a 0.4mm…
