Counting matching models…
This bracket is for mounting the RainPoint 201P 2-Zone Sprinkler Timer on a wall. The arms are flexible enough to allow the timer to be removed for changing batteries or winter storage. Settings: Filament Overture PETG Nozzle 0.6 Layer…
Wall Bracket for RainPoint 2-Zone WiFi Water Timer, with 4 mounting holes for #8 flat head screws. Printed with PETG-Tough filament, 15% infill.
This is a mount for the RainPoint ITV405-DLS timer. I wasn't able to mount the timer directly to the faucet head, because my faucet was too low to the ground. This mount allowed me to attach the timer to a hose and mount it remotely. A…
Printed with Bambu P1P PLA 0.2 mm - no support
I broke the ¼" barb off my RainPoint “solar irrigation system” pump and after attempting to just add a barb back onto it (which also broke), I remade the cap with reinforced barbs. I was able to get it to seal properly enough when…
I didn't want to hang my RainPoint timer from the spigot so I made a mount for it. I printed it with ASA.
Couldn't find one to buy so made one that fits with 5mm bolts to the existing holes at the bottom of the unit. Not Shure what would work best printed it in SBS filament and is holding up good for the last 3 moths in rain and sun.
During the past winter the Rainpoint Water Timer Valve (TTV102B) froze and the male plastic hose connection cracked. The print is a tapered repair bushing (ABS ) that is epoxied into the inside diameter of the male plastic hose…
