Counting matching models…
This is a cover for the side holes on the Ikea (Blum) Rationell drawers. Clips in place just like the original covers. Printed with 0.12mm layers. You will get a nicer print with a 0.2mm nozzle but it works with a 0.4 nozzle. Voici un…
Divider Ikea Rationell kitchen drawer. The 3d printed end caps are attached to 440x130x17mm board using common hardware screws. Onshape document:…
IKEA used to sell those handy screw on dampers for kitchen counter doors until they decided to upgrade the whole kitchen to a new hinge system. The current dampers do not fit the older hinges (the new ones clamp on the new hinges). One of…
On the tall (full height) Ikea Faktum Rationell drawers there's an additional bar above the actual drawer to help take the moment of the tall drawer opening. If you've got a lot of heavy stuff in the drawer then there's even more tension…
The purpose of the spacer is to keep the compost paper bag away from the bottom of the plastic bin. Two versions are included, please use the two part split design if necessary to make it fit your build plate. Snap it together with a…
Na přání kamaráda jsem vytvořil několik dílů ze systému pořadače pro šuplík ve starší kuchyni Ikea Rationell. V průběhu let se z původních ulomily ty půlkulaté háčky, na kterých to celé drží. Díly jsou dva. Držák (číslo dílu 14606) ve…
I sadly didn't get photos of it before fully installing but the old peg broke a while ago and it was always kind of crunchy. It got really bad one day and took a look to see parts of it strewn around. This thing holds a lot of weight so I…
Print every part once, execpt number 4 and 6 each to be printed twice, no support needed Jedes Teil wird einmal benötigt, bis auf Nummer 4 und 6 - jeweils zwei Mal den Auftrag zum 3D-Drucker senden, kein Support benötigt Numbers explained…
Spacer to move IKEA RATIONELL cupboard door damper slightly further from the side of the cupboard. The plunger of the damper was landing on the inside face of the door right where there is a bump as it changes thickness, resulting in a…
Description The former IKEA Corner base cabinet pull-out fittings from the series Rationell tend to sag under the weight of the pots. In my case, the front corner hung more than 7 cm lower than the center bearing, and the pots slid toward…
I printed this without supports on the flat side with no issues.
This is the lower locking bracket for the Ikea Rationell Spinning Corner Shelf. I have redesigned it for strength Print Settings Infill: 75%+ Category: Kitchen & Dining
I printed this without supports on the flat side with no issues.
