Counting matching models…
The original cable chains for the Wanhao I3 are very small and impossible to pull the servo leads through without disassembling the connector. So I switched to a 10x15 cable chain with small doors on each link that makes routing cables a…
ReDuplicator converted to MGN12 rails on X and Z. New 90deg fan duct should allow 255mm max z height (I got 236mm with the 45deg) Most of the original STLs reused had small defects or didn't line up so I fixed those while I was at it.…
This is 3D printed corner for better stability of Z axis portal for ReDuplicator i3 printer clones. It contains only one .stl file. For correct side should be mirrored in slic3r. Print Settings Printer: dedupler Rafts: No **Supports:**…
I added 2.5mm more clearance on the gusset section of this part. The screws that are used to fix the x-axis rods in place where just barely rubbing on this bracket. Now I can use the full z height without any rubbing or binding. This will…
Bracket to mount the Wanhao i3 Plus/Maker Select Plus PSU to the side of the frame for the Reduplicator MK3x Project . This uses 3 M5 12mm bolts and T Nuts to attach the mount to the 3030 frame. I've designed it to recess 2 M4 socket head…
I used a x carriage design that allowed for a E3D v6 and Bondtech BMG and needed to extend the width of my x carriage further toward the Z tower to press the x-min sensor. It mounts to the fan screws. Works with this X carriage design and…
I recommend using this bltouch mount https://www.thingiverse.com/thing:4086282
