Counting matching models…
I had a flash of inspiration last night! As I'm still learning to design and work my printer, I thought it'd be kinda funny to make tokens based on failed calibration tests, prints, and hardware. Since Monopoly has 8 tokens I decided to…
This is the shopping trolley key for substituting the coin of 10 roubles. Allows to take it away right after use. Just turn it left and take out. Originally was published at Thingiverse: https://www.thingiverse.com/thing:3371160
The design of this model is intended to help highlight deficiencies in your calibrated and tuned settings (e-steps, flow ratio, pressure advance, z-offset, etc.), while also using a minimal amount of filament (~5g) and taking a relatively…
Prusa MMU2s F.I.N.D.A. (filament detection) Troubleshooting aid The best way to quickly troubleshoot what is going on in a machine is to have all sorts of indicators at different stages of the process. After adding the wonderful…
I've been having issues with my Mk4 (not the Mk4S) that doesn't have a high-flow nozzle, with certain filaments that just don't flow enough for the input shaping speeds. I tried using the Infill Swatch set by orax and, while fantastic for…
In the POST-PRINTING section I will tell you what to do with each test after printing is done. PLEASE READ THAT SECTION! How to print each test: 2x2x2 and 1x1x5 cm blocks: Print them with your normal settings. Use them to test general…
Be careful not to lose the spring and bearing! <smooth filament load> I printed five filler parts simultaneously using an 0.08mm Extra-Fine setting. Select one item in good condition. The print quality is working well with the image2.…
Prusa MMU2s F.I.N.D.A. (filament detection) Troubleshooting aid The best way to quickly troubleshoot what is going on in a machine is to have all sorts of indicators at different stages of the process. After adding the wonderful…
まとめ # Mech Hand V6 Mech Hand V6 is a 3D-printable robotic hand designed around a simple, modular, and easy-to-modify linkage mechanism . Each finger has three joints and is driven by one SG90 micro servo . All five fingers, including the…
Thanks again to Dajosco for his work and sharing ;)
quick open the prusa troubleshooting guide when a print fails or the printer fails. be sure to enable color change at the correct later height.
This is a wall mount for a Heathkit Troubleshooter Volt-Ohm meter. The design allows the troubleshooter to slide in and out the top so you can easily remove it to use or change the battery. Category: 3D Printing
Cheat Card for maintenance and troubleshooting on your Prusa. Values and instructions from here on Prusa's Website
