Counting matching models…
For those looking to eliminate noise from the SC846 chassis, this model replaces the entire OEM fan wall assembly with an alternative design that uses quieter hot swappable 120mm fans.
SC846 ATX PSU Mount For those of us who have removed the rackmount PSU that comes with the Supermicro SC846 chassis and replaced it with an standard ATX PSU for quieter operation, the ATX PSU is usually left to just rest inside the case.…
HDD Blank for covering empty bays for SC846 chassis for improving airflow across populated HDDs.
SCH846 Rear Fan Bracket & Caddy Low-profile fan bracket to hold the fan caddy for Supermicro SC846 chassis. These low-profile brackets provide clearance to use the complete ATX PSU Mount along with the accompanying shroud for closing off…
In my Supermicro SC846, I have the BPN-SAS2-846EL1 backplane with SAS expanders. This means that all the drives in the 24 bay must be connected through my HBA. If you're running a hypervisor, such as Proxmox, you may want your hypervisor…
SCH846 Rear Fan Bracket Low-profile fan bracket to hold the fan caddy for Supermicro SC846 chassis. Added a tab so the caddy can latch into place. This gives clearance for the ATX PSU Mount when used without the accompanying shroud. If…
A bracket for mounting a 360 AIO into a 24-disk bay Supermicro 846 case. Requires several other models to work. This model will not fit with the stock hot-swap power supply setup. Requires ATX Power Supply Mount –…
Two-piece parametric OpenSCAD caddy holding two Samsung PM1733 (or any 15mm U.2 2.5") NVMe SSDs in a Supermicro SC846 chassis, using twang's HDD base mount rail system. Boolean-split at the drive boundary so each half prints flat without…
This model is a slimmed-down rear fan bracket for the Supermicro SC846 chassis, based on the original design by twang. It was modified to allow proper clearance when using the custom ATX PSU shroud. The bracket has been reduced to a…
Two-piece parametric OpenSCAD caddy holding two Samsung PM1733 (or any 15mm U.2 2.5") NVMe SSDs in a Supermicro SC846 chassis, using twang's HDD base mount rail system. Boolean-split at the drive boundary so each half prints flat without…
