Counting matching models…
Use the screws of the display to fix the case to the module. The holes for the screws have to be drilled by you, but they are marked and can be found easily. Holes left by the printer would result in a messy print (at least for FDM).…
This is a side plate for the breadbin case C64 for installation of an internal SD2IEC device. The main purpose was to install additional buttons for disc image change and an on/off switch. The used switches can be clicked into the side…
This is a case for the SD2IECplug project , which is my layout for the SD2IEC floppy drive replacement for 8 bit Commodore computers. The SD2IECplug v2 was never specifically designed to fit into an enclosure, so this case makes a few…
I needed a case for the SD2IEC Card reader kit offered by Fascination C64. You need the bottom and top half, 3 of the back knobs and one side knob. The case can be mounted together with M3 screws. They fit into the mounting points of the…
This project is for a fully-printable enclosure for the cassette-port-powered Bitsretro version of the well-known SD2IEC project (link below). Modern electronics just keep getting ever smaller, with some stuff already being too small to…
A case for the Board Folk SD2IEC / EPYX FASTLOAD device for the Commodore 64. Clip the topper into the top case first before putting in the SD2IEC / EPYX FASTLOAD device into the top shell and then clip the bottom shell on. You can use a…
Case für das MSD2IEC SD-Kartenmodul für den Commodore C64.
