Counting matching models…
A replacement part for the rear feet of the Sharkoon Skiller Mech SGK3 keyboard. The original feet start to crumble after a few years. This replacement was designed as close to the original dimensions as possible. They nicely snap into…
I made 2 versions: 1- without using the original rubber, 2- in which I used the original rubber from the broken leg. Requires supports. I printed on a layer of 0.07mm. It came out very nice.
verstärkte Füße für die Tastatur. Gedruckt in PLA ist es etwas schwer zu installieren, dafür hält es bei mir ewig. reinforced feet for keyboard. Printed in PLA, it's a little difficult to install, but it lasts forever for me.
A sliding hard drive rail for 3.5" drives. This is an extended length version designed for primarily for shucked disks which only have 2 instead of the typical 3 screw holes on either side. The rails which are included with the cases I…
Hier ein Lüftergitter bzw. ein Case-Mod für die Sharkoon S25-W bzw. S25-V ATX Midi Tower. https://de.sharkoon.com/product/19304 https://de.sharkoon.com/product/19298
Slim palm rest for sharkoon purewriter keyboard. Added some optional riser pads to get a better angle. Since my printer is too small i made 2 halfs. 5mm*1mm holes for magnets to hold the sides together. Maybe add some sticky tape or…
Made with Blender in works-for-me way, no planned modifications. Needs 250x250 mm printer
Hier ein Lüftergitter bzw. ein Case-Mod für die Sharkoon S25-W bzw. S25-V ATX Midi Tower. https://de.sharkoon.com/product/19304 https://de.sharkoon.com/product/19298
Replacement clip for orginal sharkoon skiller keyboard Print Settings Printer Brand: Creality Printer: Ender 5 Rafts: Doesn't Matter Supports: Yes Resolution: 0.2 Infill: 100 Filament: PLA Category: Office
Nice little holder for my headset. Used a M5 Screw to hold the metal top of the headset Printed with: Neptune 2 0.6 mm Steel Nozzle 0.32 mm Layer Height
This is an early version of a 10-disk 2.5" SSD caddy for the Sharkoon QB1 mini-ITX case to replace the provided SSD/HDD mounting frame. It's a very tight fit in the available space, even after (manually) countersinking the drive mounting…
