Counting matching models…
I didn't like the gray cable ports that I got with my Ikea desk so designed these replacements. The main reason I wanted something different was the color but my design has a couple advantages over the original Ikea part. They are easier…
It is best to print with PET plastic; I printed the bolts separately with 95% infill for better strength. No support nedded for printing.
Replacement and longer version of mounts for Signum cable organizer. 80 mm version is close to the original one. Countersunk holes for the mounting are M5 (the original screws fit), while the top hole for the thumb screw is M8×1.25 thread…
Assembly that screws into the Thunderbolt dock and can be clipped into a Signum cable channel. Allows for easy installation and removal + simple cable routing directly into the cable channel above. The part can be mounted in any…
A cover for the Ikea Signum cable management tray to hide the messy cables. It just clips in place, leaving a little gap between each print for aesthetic reasons. Can be printed on a 200mm build plate. I sadly lost the original step file…
One knop was broke, so I re-engineered a new one. Designed in TinkerCad. For holding the knob I used a 8x8x2mm M3-nut and a M3x14mm hex-screw. Maybe you do not need a screw at all? Printed on my Bambu A1 with AMS lite in multicolor (Black…
If you’ve lost one of the plastic pins that secure your Opel/Vauxhall Signum’s cargo cover, you know how frustrating it can be to lose trunk privacy. I faced the same issue after a trip to the car wash and decided to solve it by designing…
I needed to cut Ikea's Signum Cable Managment System down to a shorter length. After cutting, I was left with some very sharp ends. Fearing for the safety of my cables, I used Xowyre's SCAD file to make some end caps. 2 sizes (2.8 &…
This is a jig for positioning the little feet that come with SIGNUM cable canals from IKEA. Step file included should you want a different distance from the table's edge.
i created cupholder for opel vectra c / signum. is very good and i add wall if u wanna keep your opel organize
My Signum Rack was sitting too close to my desk to fit my power strip, so I designed two 25mm spacers to push it down. The spacers are designed to fit two M8 Bolts. I printed mine using Fuzzy Skins because I was experimenting with them,…
