9 models
how to build All sensors are from Sensirion. They all use I²C bus. The two little ones can withstand 3.3V and 5V, the PM sensor needs 5V. I choose to operate the little ones at 3.3V to minimize their heating. The SCL and SDA wires can be…
This enclosure was built to house a Sensirion SPS30 (particulate matter sensor) and an Adafruit BME280 (temperature, humidity and barometric pressure sensor) for an outdoor weather station. The goal was to have an enclosure that could be…
Remixed the housing from JT https://www.thingiverse.com/thing:2820147 in order to support: ESP32 Feather Huzzah with 2.4" TFT Wing Bosch BME280 sensor Sensirion SPS30 sensor Source code can be found here:…
A Bracket to hold a Sensiron SPS30 particle sensor. The Bracket can be glued onto the SerialCarrier of the SensorBox (V2) . The Sensirion SPS30 is only snapped in. The Bracket respects the design rules from the Sensiron datasheets and…
This adapter is meant for SPS30 particular matter sensor. It allow to use it with SDS011 mount holes. Of course - device has to support SPS30 since it has different protocol than SDS011. First version - it will require modifications.…
Project page : https://www.klosko.net/blog/=clanek=airqmonitor-monitor-kvality-ovzdusi (CZE)
This is a 2-part indoor housing for the WeatherDuino Air Quality Monitor III with Sensorion SPS30 for particle measurement, MH-Z19 for Co2 measurement and 1.3 inch OLED. You can find information about the WeaaterDuino here:…
how to build All sensors are from Sensirion. They all use I²C bus. The two little ones can withstand 3.3V and 5V, the PM sensor needs 5V. I choose to operate the little ones at 3.3V to minimize their heating. The SCL and SDA wires can be…
