Counting matching models…
After trying to implement some mods that I found on Reddit and forums, and not being satisfied, I decided to develop my version using gears. Printed with 0.2 mm height, in PLA, 5 walls, 100% infill (I think you can reduce the infill, but…
A simple stepless mod for the fellow ode grinder. Contains a debossed disc that fills in the detents in the Ode's adjustment disc. Also included is a pin that replaces the original steel pin. I printed this in TPU and glued it to the…
The Turin SD40 is a good entry level grinder, but it's major draw back is the relatively large stepped grind size adjustment locking mechanism. This worm drive and dial gear replaces the original and allows for stepless grind size…
Heyho there are solutions out there for a better fine tuning of the comandante grinder. But I didnt like all of them :D The mods for the existing Wheel arent that accurate and still not stepless and if you use a wing nut to secure a…
This part replaces the internal speed stop plate in the Dremel Lite, allowing for smooth speed adjustment instead of four fixed steps. An added benefit is that the tool now starts at 4000 RPM instead of 8000 RPM, providing better control…
Extra hardware required for the crank: M3 x 20mm screw to fix the crank body to the worm gear shaft, you can also use glue. M3 x 10mm screw for the crank handle. This is not a hard mod since it mounts to the same holes the grinder already…
Case for stepless drill bits. Will eventually revise for magnets to keep closed. Category: Tool Holders & Boxes
This is a stepless drill bit case, with holes that are 20x80x22 to fit varies sizes of stepless bits. This was designed to fit the 3 pack with sizes: 3/16 to 1/2 in.; 1/4 in. to 3/4 in.; 1/8 in. to 1/2 in. but can fit any item or bit that…
