Counting matching models…
When I built my yeethammer my plunger tube would torque down on whichever side it was being pulled from, and as a result the plunger wouldn't always latch. I found myself spreading my hand and grabbing the nut side of the bolt as well and…
The Yeethandle by Reboot is an awesome model and looked to solve an issue I was having with my Yeethammer - the torque from a single side bolt handle would cause the bolt to jam. However my E3v2 wasn't going to print the single piece…
A handle for a 6.3 mm Hex Shaft. Intended to assist with nozzle changes. Design considerations: Accept a standard 6.3 mm Hex Shaft. Use M3 bolts and nuts to secure shaft (likely in spares from printer build and mainenence). Large enough…
make sure you ad a pause right before printing the bridging layer. use support blocks in the allen key hole.
I recommend fuzzy skin for better handling and print it up side down In my prints i added 50 percent infill in the bottom 5mm to make it less top heavy even though the magnet should hold it up plenty strong. I added a thin sheet of steel…
This is a remix of Ivan Urbánek's MTA used in his version of the Hadley Telescope with support for baffling. I tried to keep it as close to the axis as possible to reduce the need for balancing while still allowing an appropriate amount…
I recommend fuzzy skin for better handling and print it up side down In my prints i added 50 percent infill in the bottom 5mm to make it less top heavy even though the magnet should hold it up plenty strong. I added a thin sheet of steel…
this masthandle solfes the problem of carrying a foilboard without a handle on the hull. it only fit on a Gong-Galaxy mast v1 (v2 ist much bigger). i printed it with 15% infill. but of course i am not shure if this is strong enough. but…
