Counting matching models…
Different width Sram Level TLM/Ultimate bleed blocks (part.no. 11.5015.014.090). The bleed block comes with multiple sizes: * 12mm (default) - Use when bleeding brakes which afterwards will use new pads * 11mm - Use when bleeding brakes…
This is an old design that I imported from my prints on Thingiverse. I needed a bleed block after shortening the brake hoses on my new bike. This one works a bleed block and piston spreader. It works on the Sram Level TLM and Ultimate…
Tlmič hluku skriňového ventilátora v kombinácii s uhlíkovým filtrom pre tlačiareň Elegoo Centauri Carbon je vhodný hlavne pre užívateľov, ktorí si prerobili v tlačiarni vnútorný okruh prúdenia vzduchu podľa tohto modelu: Elegoo Centauri…
This is a holder keeping your STANLEY TLM40 Pocket Laser Distance Measurer / Rangefinder nicely on your Honeycomb Storage Wall (HSW) for easy retrieval. The device sits tight in the pocket - this is intended as I do not use it all too…
While building my GOODMAN Zone, i found out that the DeWalt TLM30 Laser Rangefinder, which is mentioned and shown all over the project, and for which a mount is provided, is now End-Of-Life and has been replaced with the DeWalt TLM40 -…
The TLM is a good delta printer, but uses a bowden system. I wanted to improve the printing capability by making it direct drive. To do this, the effector arms needed improvement to handle the inertia of the hot end assembly and extruder.…
Complete set of 3d printable part files for the enclosure The STL file names indicate how many parts are to be printed, including if they need mirroring. e.g. ‘ Hinge A x2+2M.stl ’ means you need to print 2 normally and 2 mirrored. The…
infil 100% podpery len na podložke layer 0,1 PETG
Printed with Prusament PETG and textured sheet face down. Model files are upright to choose between face down or face up depending on the final finish. Push in place Letters and Border. 0.25mm Layer height 2 perimeters 3 bottom and top…
This project involved redesign of a coworker's original hanger prototype to accept TrippLite TLM626 power strips. These were also designed to mount on a 1" thick desktop surface with enough room for thick dual-stick tape (Gorilla tape or…
Panoz Esperante GTLM as a 3D Model. This design can be scaled to any size in your slicer. Print flat with ~5% infill to save material. Perfect as decoration. Category: Signs & Logos
In my case, one pin is cracked but stays in place. This fix supports both pins so they cannot crack more. Print model in vase mode with no bottom layers. Use 1 mm extrusion width. Use PETG, don't use PLA (motor gets hot). Steps: Print the…
I print this using Bambulab TPU 95a filament as I do not want hard plastic to scratch the expensive microphone. I made it slightly larger than it should be, so it might be able to fit most of the TLM models.
Ein weiterer Halter für meine Gridfinity Sammlung, hier für den Stanley TLM40 Laser Entfernungsmesser ( Amazon )
