Counting matching models…
Tri-Bahtinov Mask for C8 and Edge HD 8 Hyperstar with cooled ZWO/OGMA/Touptek 80mm diameter camera This Tri-bahtinov mask will fit C8 or Edge HD8 in the Hyperstar configuration with out having to remove the camera. outer diameter is 203mm…
A small tube ring for a Touptek 2600 camera which can be fitted with a long M8 screw to attach large 20mm washers as a counter balance for the filter wheel. This is useful if you use a rotator that will change the balance of the image…
A 15.5mm thick filter drawer for 2 inch filters that takes up lesser backfocus distance compared to commercial options. The drawer uses 2 6x3mm magnets to stay in place. The design uses 4 long (20mm) M3 screws and 2 short M3 screws so the…
I recently purchased a ToupTek AFW 5x2" filter wheel. Annoyingly my expensive Baader filters were too tall to fit into the filter wheel, as there is a little raised board at the bottom of the AFW with two sensors on which the filters were…
A focuser for the touptek. made the same way as my bresser focuser. just smaller and for the gs ar verisons. Its made with a nema 11 motor and 14:1 gearbox from stepperonline.
The ToupTek AFW filter wheel has screw holes either side to attach tilt plate and OAG via screws. If your using the M54 adaptors to attach to telescope and camera (rather than the screws), then the screw holes are not covered and could…
The ToupTek AFW filter wheel has screw holes either side to attach tilt plate and OAG via screws. If your using the M54 adaptors to attach to telescope and camera (rather than the screws), then the screw holes are not covered and could…
Print settings: Material: PETG Infill: 20% Perimeters: 5 Layer height: 0.2 mm from 0 to 60 mm, and 0.1 mm from 60 to 70 mm to achieve more accurate thread printing. This is a case for the ToupTek AE676C camera. It adds a 1/4" mounting…
