Counting matching models…
A headphone hook designed to be glued under a desk or under a shelf using double-sided tape. Print instructions The "shelf" part of the hook is ca. 50 mm deep, scale the model accordingly if your headphones have bigger bridge than that.…
Print approx. €6.23–€7.61 excl. taxPreliminary estimate for one variant
If you are a helicopter underslung instructor or work with slingloads, this is the sign for you.
Print approx. €2.03–€2.48 excl. taxPreliminary estimate for one variant
A challenge of the MMU design for those of us who use enclosures is that the lights are not visible without a view of the top of the unit. This control box moves the control board to a better location that is both easier to see and easier…
I created this to mount my work laptop and free up some desk space, as well as give the laptop a bit more air. I printed mine with PETG @ .2mm layer height. Obviously you need 2 side brackets. I made it compatible with 10mm washers,…
I needed to replace my janky projector setup that hung it under a shelf. This is what I came up with in Onshape in a couple hours. You will need a ½ inch long ¼" 20TPI bolt to mount the projector to the clamping structure. the opening for…
Designed for mounting a Bontrager Ion 200 RT underneath a Garmin out-front mount. Category: Sport & Outdoors
I just add a little space for the Color-Code-Clips to the nice model from universaljoint . And I created another MMU2 frame holder with a flatter angle. Update: Add Color-Code-Clips with Numbers, can be printed in multicolor Category: 3D…
The positions of the color clips now match the position of the corresponding LEDs on the control panel. This leads to smaller clips as the overall width of the cutout had to be reduced to 66mm due to symmetry reasons. The clips are now…
I initially mounted my MMU2 on an i3 MK3. At the time I used the MMU2 Underslung control panel mount . Since then I have upgraded to MMU2S and MMU3, but have always used the Undersling control panel mod. I now have a Core One, and didn't…
This is a new X endstop mount for MakerFarm i3v printers to extend X travel further to the right. This allows the left extruder nozzle on dual extruder setups to reach more of the bed. On the 12" i3v with the Itty Bitty Double Flex…
Designed to fit TBS Caipirinha for a convenient battery mounting area as well as a grip for hand launching. Print two side pieces and one front fairing all with no support. Using a sharp knife create two slots for the side pieces to fit…
I initially mounted my MMU2 on an i3 MK3. At the time I used the MMU2 Underslung control panel mount . Since then I have upgraded to MMU2S and MMU3, but have always used the Undersling control panel mod. I now have a Core One, and didn't…
