Counting matching models…
NEW VERSION 4 SOON! Version 4 is coming soon with an internal fan for drying and fully optimized cable routing. Since new parts need to be printed for Version 4, I have created a 2-part conversion kit. This allows you to update your…
I have found that the inside of my wetsuit boots struggle to dry without being propped open, which is difficult to do, especially when away. So, I quickly designed this! These are designed to go inside your wetsuit boots to keep them…
Tired of stinky boots after surfing? This is the solution I found. I hope you like it too. Note that I made some improvements to the shared model, after I did print it's first version, in the picture.
This is the Wetsuit Wrangler which is designed for stripping off the sleeves of front zip wetsuits. The problem it attempts to solve is the challenge of taking off the left and/or right arm sleeves of your wetsuit after expending all your…
This is a simple, fully 3D-printable wetsuit hanger. The assembly does not require any additional screws, hinges, or extra hardware, all parts will clip into place. This also allows the hanger to be taken apart again for easier storage.…
Hanging wetsuits on a traditional clothes hanger is a good way to wear out the shoulders, especially if you hang them up wet and heavy. This is a design to hang a wetsuit folded over in half at the torso, where it's much stronger.…
The hook itself was printed in ASA, other parts in PLA
I found the model from DaHouzKat and thought I would modify it to add some extra hooks that are nicely spread out allowing me to hang my wetsuit gloves and wetsuit hood. Of course, this could be used for anything (assuming it isn't too…
I used a plastic smoothie bottle. Diameter may be scaled easily. Holes in the cap can be widened with a drill afterwards if necessary.
!Important: print in vase mode with line width of 0.65mm, no bottom layers! This drying aid is meant to help when you dry your wetsuit boots, and to keep the boot open when standing upright. To use it, print two of the appropriate size…
I have bought branded products which are essentially a silicon sock for storing a key, but I found they broke/tore after minor use. A problem with keys is they punch through whatever you're wearing ( e.g. wetsuit) and tear a hole in your…
This item gives you anchor points and lanyard holes for the Hover Aqua Wetsuit neoprene cover. Simply screw it on to the Aqua Wetsuit neoprene cover and you can enhance the way you keep the drone secure and easily accessible. There is…
This is a simple, fully 3D-printable wetsuit hanger. The assembly does not require any additional screws, hinges, or extra hardware, all parts will clip into place. This also allows the hanger to be taken apart again for easier storage.…
Tired of stinky boots after surfing? This is the solution I found. I hope you like it too. Note that I made some improvements to the shared model, after I did print it's first version, in the picture.
Wetsuit & Accessories Hanger – The ultimate solution for drying your wetsuit and gear with ease. Built for durability and versatility, this mountable and dismountable hanger is perfect for wetsuits, gloves, boots, hoods, and other…
WHY Hanging your wet surf or diving wetsuit on a normal hanger stretches and thins out the shoulders. This wetsuit saver can keep your wetsuit going for much longer. MATERIALS PVC Pipe: note that Ø32x3mm thick or NPS 1 inch is strong…
