Wetsuit Boot Dryer Insert Windsurfing Water
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An insert is placed inside wetsuit boots and gloves to keep the inside exposed to fresh air to dry.
- Rating
- 0 / 5
- Likes
- 20
- Downloads
- 83
- Makes
- 0
- Views
- 701
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- GNU General Public License v3.0
I have found that the inside of my wetsuit boots struggle to dry without being propped open, which is difficult to do, especially when away. So, I quickly designed this!
These are designed to go inside your wetsuit boots to keep them open, allowing the wet air to escape.
I have found they can also be used to do a similar thing with sailing gloves.
If you have smaller boots (I am a size 12), then I would suggest scaling the model down slightly.
I printed with PETG for the flexibility over PLA so it can be tossed in my bag afterwards. If needed, you can up the wall loop count.
I was able to print on my MK3.5S without support. I would advise a raft if you can.