Wetsuit Boot Dryer Insert Windsurfing Water
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An insert is placed inside wetsuit boots and gloves to keep the inside exposed to fresh air to dry.
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 83
- Wydruki
- 0
- Wyświetlenia
- 701
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- GNU General Public License v3.0
I have found that the inside of my wetsuit boots struggle to dry without being propped open, which is difficult to do, especially when away. So, I quickly designed this!
These are designed to go inside your wetsuit boots to keep them open, allowing the wet air to escape.
I have found they can also be used to do a similar thing with sailing gloves.
If you have smaller boots (I am a size 12), then I would suggest scaling the model down slightly.
I printed with PETG for the flexibility over PLA so it can be tossed in my bag afterwards. If needed, you can up the wall loop count.
I was able to print on my MK3.5S without support. I would advise a raft if you can.