Counting matching models…
I bought the Geekworm X301 expasion board for my Raspberry Pi Zero 2W, and since there is no enclosure available, I used some CAD magic and came up with this. There is room for the C296 heatsink and a 4010 fan. I use a Noctua NF-A4x10 5V.…
Here are some various remixed models I have modified while I have been putting my Layerfused X301 printer together. Most of these have to do with the hotend, but not all of them. Here is a link to the Layerfused website.…
This was my very first design with Fusion 360. The BLtouch mount places the probe on the left of the hotend as shown in the rendered photo. The offsets should be pretty close to X= -21 Y= 2.95 Z= -2.640. Please double check these offsets…
SkirtFlow M8P – 4x3010 Side Intake Stepper Driver Cooling Duct for BTT Manta M8P SkirtFlow M8P is a side-intake cooling solution for the BTT Manta M8P designed to pull cleaner air from the printer skirts rather than recirculating warmer…
Webcam holder for Layerfused X301. Print Settings Printer: Layerfused X301 Rafts: No Supports: No Resolution: 200 Infill: 20 Filament: PolyMaker PLA Category: 3D Printer Parts
A Mount with screw holes for the Odoga SGR-NX3012SK-3 Inverter. The 2 Plates use the screws, that are already in the Inverter. Just unscrew them and screw them back in with the mounting plates in between. This was designed specifically…
These brackets slide into the M5 screw holes in the motor mounts to position a fan directly below the X/Y motors on the Layerfused X301. I found that my motors were getting fairly warm despite the heatsinks and wanted to address the…
