Counting matching models…
UPDATE: As with my original stand, I had issues printing this when the two pieces were not placed on the bed in the exactly the same orientation. (The honeycomb infill would ‘move around’ to get a best fit). In that case my support rods…
HexYeah Bookends! The bookend with a modern look. HexEnds - I would use these for smaller books HexEndsSupportLeg - added a front support leg to allow for the weight of the books to support the bookend, while keeping the back of the base…
I needed a bit more hight to exend the range for the IKEA Växer LED grow light holder so i produced an addon! The model can be stuck on the end of the original tower when sized down to 80% of the IKEA Växer LED grow light holder. It…
Phare d'Alexandrie mais doit surement regrouper les pièces.
Simply print and then plug between the extender and the brush. Vacuum used: https://www.amazon.de/gp/product/B089SK5BMY Source: https://a360.co/3zrqq2i
I added 2mm to the loop part of the Xend_Cover so the cables won't be tight and constrained. The overall length is the same. It has just a little more room than snug. Allows for additional wires that you may need for something like an ABL…
Replacement for the Spanninga CC02 cable connector, the small one-piece plug that clamps the power wires into the back of Axendo 40, 40+ and 100 headlights (dynamo and e-bike XE versions). The original part is not sold separately anywhere…
