6 models
Decorative end cap for two ø2mm paracord ends, to either close a loop or set a colour accent. Also works for a single ø4mm end. no knots no tools no extra parts no support geometry This print is tested with and developed for 0.25mm…
Print approx. €0.09–€0.11 excl. taxPreliminary estimate for PETGSource material: PET
Die Original Slider des Reißverschlusses meiner Wellensteyn-Weste sind gebrochen; somit konstruierte ich in FreeCad neue Slider. Der Slider besteht jeweils aus 3 Teilen, welche nachher zusammengefügt werden. Der Bügel wird zuerst hinten…
Print approx. €7.61–€9.30 excl. taxPreliminary estimate for one variant
Hier habe ich Slider u.a. für 2-Wege-Plastikreißverschlüsse 5mm konstruiert. Der Slider besteht jeweils aus 3 Teilen, welche nachher zusammengefügt werden. Der Bügel wird zuerst hinten eingehakt und dann vorsichtig nach unten gedrückt -…
Print approx. €4.69–€5.73 excl. taxPreliminary estimate for one variant
Sewing machine presser foot for zippers. Print with sufficient detail in something that will give you good bridging and little stringing, optimised to need no supports. Keep in mind that the attachment bar is not metal so don't just drop…
What makes it special I made this for suitcase zippers, after thinking about how easy it is to lose track of a bag in a busy airport or on a crowded street. It prints fast, and I kept it simple enough for a beginner to run without a lot…
I Printed it with 50% infill may it not realy mather because its such a smal part. I used support to get a cleaner finish in the holes for the zipper. For different sices i just scaled up or down. The curent design is made for 5mm wide…
