2nd Generation Chevrolet Chevy Silverado phone holder 2007-2013
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
V3Moved the phone farther out and angled/tilted it up/back at 75 degrees (or leans back 15 degrees). I removed the…
- Ocena
- 0 / 5
- Polubienia
- 44
- Pobrania
- 314
- Wydruki
- 0
- Wyświetlenia
- 2630
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
V3 Moved the phone farther out and angled/tilted it up/back at 75 degrees (or leans back 15 degrees). I removed the bracing and printed in PETG and it's been working fine.
Added Fusion 360 files (f3d, 3mf, stl).
V1 Designed to fit the passenger-side cubby but at a 45* angle to face the driver.
It uses the two holes for the rubber mat that fits in there to hold it in place, wedging against the top in the back.
I measured for an iPhone 13 with a case: 79mm wide, 13.5mm deep, and 75mm tall supports. Charging port is 13.5mm X 6.5mm, offset slightly towards the front.
This is an original design I made, and the bracing is way overkill, but I printed in PLA and am hoping it'll keep it from warping too bad in the South Texas heat.
Print Settings
Printer Brand:
ELEGOO
Printer:
ELEGOO NEPTUNE 4 Max
No
Supports:
No
50%
Filament: Polymaker PETG yellow
Notes:
0.4mm nozzle
0.4mm line width
0.32mm layer height
Used the rubber mat that fits in the cubby as the base for measurements to line up the holes & dimensions. Used a digital caliper to take measurements, then printed a few 1mm thick bases to check fitment.
Extended it out past the cubby and angled it 45to face the driver, tilted phone upwards 15 for better viewing.
I measured it to fit an iPhone 13 with a case.
Category: Automotive