1 / 9
2nd Generation Chevrolet Chevy Silverado phone holder 2007-2013 — image 1
1 / 9

2nd Generation Chevrolet Chevy Silverado phone holder 2007-2013

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

V3Moved the phone farther out and angled/tilted it up/back at 75 degrees (or leans back 15 degrees). I removed the…

Rating
0 / 5
Likes
44
Downloads
314
Makes
0
Views
2,630
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Share Alike

V3 Moved the phone farther out and angled/tilted it up/back at 75 degrees (or leans back 15 degrees). I removed the bracing and printed in PETG and it's been working fine.

Added Fusion 360 files (f3d, 3mf, stl).

V1 Designed to fit the passenger-side cubby but at a 45* angle to face the driver.

It uses the two holes for the rubber mat that fits in there to hold it in place, wedging against the top in the back.

I measured for an iPhone 13 with a case: 79mm wide, 13.5mm deep, and 75mm tall supports. Charging port is 13.5mm X 6.5mm, offset slightly towards the front.

This is an original design I made, and the bracing is way overkill, but I printed in PLA and am hoping it'll keep it from warping too bad in the South Texas heat.

Print Settings

Printer Brand:

ELEGOO

Printer:

ELEGOO NEPTUNE 4 Max

**Rafts:**

No

Supports:

No

**Infill:**

50%

Filament: Polymaker PETG yellow

Notes:

0.4mm nozzle
0.4mm line width
0.32mm layer height

How I Designed This

Used the rubber mat that fits in the cubby as the base for measurements to line up the holes & dimensions. Used a digital caliper to take measurements, then printed a few 1mm thick bases to check fitment.

Extended it out past the cubby and angled it 45to face the driver, tilted phone upwards 15 for better viewing.

I measured it to fit an iPhone 13 with a case.

Category: Automotive

Tags