1 / 2
Towel Holder for Bike Stand / 38mm Pole Mount — zdjęcie 1
1 / 2

Towel Holder for Bike Stand / 38mm Pole Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A paper towel holder for a bike stand or similar with a 38mm post.

Ocena
0 / 5
Polubienia
1
Pobrania
13
Wydruki
0
Wyświetlenia
106
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Garage
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

Three versions. Wide and narrow vertical print. Or trimmed horizontal print.

I went with the wider vertical version and learned a few things. I printed in PLA+ without brims and couldn't find the print after it had finished. LOL. It was knocked over just as the printer finished. I also just printed with 2 walls and 10% infill and the threads cracked. I epoxied that and used it to avoid a reprint. 

I would recommend PLA+ or PETG with 6 walls and higher infill! Also, given the height of the post, a wide brim and some bed glue might prevent the knockdown I had.

If you want to check the thread fitment, print the small test piece (and cap) before the post. If it fits well, use it to cap the post after that prints!

 

The horizontal print is asymmetrical but will have stronger threads. About 15% less filament used and my slicer shows half the print time. Wins all around.

 

*  The thread happens to be ¾ garden hose thread if some other accessory would be more useful for you!

Tagi