TPA3116 Bluetooth amplifier enclosure case for sanwu board module
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Enclosure for TPA3116 Bluetooth amplifier board. You need to print 5 of the button pins
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 282
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Enclosure for TPA3116 Bluetooth amplifier board
You need to print 5 of the button pins. Use a brim to stop warping of the top and bottom enclosure, and for the button pins as it is very small.
Note 1: Clean the 5 holes for the button pins with a 3.5 mm drill and also use the 3.5mm drill to clean out the 4 corner holes, about 4mm deep
Note 2: I had a 5mm hole-drill that had the correct inside diameter to clean the upright pins of the bottom plate.
Note 3: Clean all the button pins for any irregularity on the outside
Definition of buttons:
Back, Next, EQ, Mode and Play
<< >> E M >
Print Settings
Printer: P3Steel
Rafts: No
Supports: No
Resolution: .2mm
Filament: Verbatim and RoHS ABS, red and PETG, black Red and Black
Notes:
I printed both the ABS and the PETG with a brim to stop some of the corners lifting and deforming the enclosure ( the first print lifted in the corners )
Please add a photo of your print to Makes