TPA3116 Bluetooth amplifier enclosure case for sanwu board module
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Enclosure for TPA3116 Bluetooth amplifier board. You need to print 5 of the button pins
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 33
- Makes
- 0
- Views
- 282
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Enclosure for TPA3116 Bluetooth amplifier board
You need to print 5 of the button pins. Use a brim to stop warping of the top and bottom enclosure, and for the button pins as it is very small.
Note 1: Clean the 5 holes for the button pins with a 3.5 mm drill and also use the 3.5mm drill to clean out the 4 corner holes, about 4mm deep
Note 2: I had a 5mm hole-drill that had the correct inside diameter to clean the upright pins of the bottom plate.
Note 3: Clean all the button pins for any irregularity on the outside
Definition of buttons:
Back, Next, EQ, Mode and Play
<< >> E M >
Print Settings
Printer: P3Steel
Rafts: No
Supports: No
Resolution: .2mm
Filament: Verbatim and RoHS ABS, red and PETG, black Red and Black
Notes:
I printed both the ABS and the PETG with a brim to stop some of the corners lifting and deforming the enclosure ( the first print lifted in the corners )
Please add a photo of your print to Makes