BTT Eddy Probe Easy Adjustment Mount

It is really useful that BTT have designed the Eddy probe to fit the original stock sensor on the Voron Stealthburner. Unfortunately the sensor is well and truly buried when the SB is assembled. Therefore at least the SB fascia has to be removed for adjusting the height of the probe. Accessing the boot button a whole different story.

This little mount reverses the fixing detail so the M3 x 25mm bolts supplied are fixed from the rear, allowing adjustment without any disassembly of the SB. The mount is primarily a nut keeper to hold the nuts in situ when adjusting

I have also included a lever so when Eddy is pushed upwards to the top of the travel the lever depresses the Boot Button allowing firmware flashing in situ.

In addition to the supplied bolts in the kit you will require 2 x M3 plain nuts for the forward retention. To make sue nothing moves when adjusting a drop of super glue in each nut socket may be prudent.

I have included integrated support where required. The models will need to be adjusted in the slicer for optimum print orientation.

Included versions for both stock and UHF extended versions. The standard version will fit both but the UHF version will allow the boot button depression without moving the USB cable too much.

I have also uploaded my extended x carriage mounts which I use with my Rapido UHF and a 2-3mm Z Offset spacer for probe height adjustment.

This tiny 14 minute print may save a lot of time!

Please note: I have tested the UHF version and works as expected. To date I have not proven the standard size.

BTT Eddy Probe link: BIGTREETECH Eddy – Biqu Equipment