1 / 6
Wall Spacer or Corner Mount for TP-Link EAP615, EAP225, EAP235
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
fully parametric FreeCAD model to generate a wall-spacer or a corner-mount for corners of 60° to 180°
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 103
- Wydruki
- 2
- Wyświetlenia
- 611
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (8)Wydruki i komentarze (Wydruki: 2) (Komentarze: 4)Remiksy (0)Kolekcje (11)Powiązane
- printing works with nozzle size up to 0.6mm and layer height 0.32mm
- spacer can be fixed to wall with screws or double sided tape using the flat area
- flat wall model does not need supports
- for wall corner models the use of automatic paint-on supports only, is recommended
Please post a make, if you like the model. I would very much like to see it in use.
FreeCAD model can be configured in following ways
- mount in wall corner for all degrees of wall, even 180° for flat wall is possible
- size of cable hole or no hole at all
- depth for fitting panel mount or no depth for better printing
- distance of screws
- screw sizes
- dimensions to fit other APs
there are several pre-defined configurations, which can be selected from the Body property mount_configuration drop-down
If you need a specific wall corner configuration and don't want to run FreeCAD, just ask.