CR Touch Holder for Red Squirrel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
With the arrival of the new CR-Touch from CREALITY, I wanted to create a support compatible with this Fan Duct from Red
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 109
- Wydruki
- 3
- Wyświetlenia
- 532
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
With the arrival of the new CR-Touch from CREALITY, I wanted to create a support compatible with this Fan Duct from Red Squirrel for Ender 3. It is done.
To insert the nuts, simply place them above their location, pass the screw through the hole and tighten the nut, it will fit into its location by itself.
Rafts: No
Supports: Yes
Resolution: 0.20
Infill: 20%
EDIT : After reading some comments explaining that the support was not low enough, I corrected the model in order to offer you a V2 taking into account the remarks (support lowered by 4mm).