1 / 1
Tapo C100 peephole slide-in mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Slide-in mount for the Tapo C100. Originally designed to support peephole function, with cable management.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 520
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (11)Powiązane
This is a slide-in (rail style) mount for the Tapo C100. It was originally designed to support a peephole doorbell camera function, allowing a dynamic placement within the mount for optimal focusing distance relative to the peephole lens (about 5 cm between the camera and the lens itself).
The model also has cable management holes on both sides for the power cable, just be sure to insert the cable before fixing the mount to your door with adhesive. :)
Printing recommendations
- Print on flat side (where the double sided tape would go).
- PLA is OK, the camera is not that heavy, and the rails provide a snug fit to hold the camera firmly in your desired position.
- Brim or supports are not needed, just make sure your printbed is clean.
- Layer height should be between 0.10 - 0.20mm.