Ender/Voron Switchwire Logitech C270 Mount with Zip Tie Holes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mount for the Logitech C270 Webcam on the X-Axis Extrusion of an Ender Switchwire Conversion. Now with zip tie holes!
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 285
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
This is a remix of Giwi's Enderwire Logitech C270 Webcam mount but with cable management.
As before, replace the original M3x16mm screw with an M3x20 to mount to either the left or right XZ bearing block (I prefer the right and have included a replacement cable cover to allow the camera cable to run inside the wire harness/chains). Use the replaced M3x16 to connect the C270 to the mount.
NOTE: This modification will not be a perfect fit for the all Switchwire conversions (for example the V1) since it does not counterbore the M5 bolts on the XZ bearings.