Desktop stand for Magnehelic and Manometer

A desktop stand for both a Dwyer Instruments Magnehelic differential pressure gauge and a 100mm Manometer side by side.

• Print this at 0.2mm layer height
• I heavily recommend using PETG or some other robust material and not PLA
• 3 Walls and 10% Gyroid Infill worked fine for me
• Make absolutely sure the print orientation is correct, especially the middle part needs to be on the correct side so the screw bore droplets are pointing upwards.
• The G¼" nut is optional, should you wish to use it to fixate the Manometer to the back of the plate with it. I suggest printing that one in a finer resolution like 0.1mm

You'll need the following hardware as well:

Assembly:

• 4x M6 x 20 Cylindrical head screws (DIN 912)
• 4x M6 Nuts (DIN 934)

Desk mounting (should you wish to do so):

• 4x M6 Cylindrical head screws (DIN 912) in whatever length needed for your desk
• 4x M6 Nuts (DIN 934)
• 4x M6 Washers (DIN 9021)

Magnehelic mounting and usage:

• 3x #6-32 x ½" countersunk screws
• 2x 1/8" NPT plug
• 2x 1/8" NPT hose fitting
• 1x PTFE tape

Manometer mounting and usage:

• 1x G1/4" connector of your choice, i used a NW 7,2 quick coupling
• 1x PTFE tape