Corsair SPEC-04 Hard Drive Rail Replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple print to replace a missing hard drive rail/caddy in a Corsair SPEC-04 case.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 104
- Wydruki
- 0
- Wyświetlenia
- 279
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
A simple print to replace a missing hard drive caddy for the Corsair SPEC-04. There is only one file, so mirror this in your slicer to have both sides.
Prints easily on the narrow edge without a brim, although I recommend it if you are printing quickly as the spring end tends to warp otherwise.
I do not recommend printing these out of PLA as is is prone to warping and creep at standard hard drive operating temps - PETG or something with a higher TG is recommended!
Attached project file is suitable for 1 drive!
Affixes in the standard hard drive mounting places and uses standard 6-32 x ¼" HDD screws.
Please note this is not suitable for 2.5" drives as it relies on the width of the 3.5" drive to mount properly (although you could easily screw an adapter plate in!)