BTT Microprobe mount for Stealthburner, low height
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lower-height version of djos_1475's Microprobe Stealthburner mount.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 60
- Wydruki
- 1
- Wyświetlenia
- 366
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
The “mounting ears” need to be cut off the Microprobe, I used side cutters and trimmed it with a knife. Disconnect the cable from the probe, insert it through the hole in the mount, connect it to the probe, then push the probe into place inside the mount.
I used a pair of M3x12 screws to mount it, using the supplied bracket. Also possible to use plain M3 washers, in that case M3x10 screws will be a better size. Machine screws threaded into thin plastic is a bit fragile, but seems to hold up for something this light-weight. It's easier to mount if you run the screws through the holes (to “tap” them) before mounting it on the printer, and maybe slightly chamfer the edge of the hole.