LayersFactory
Zgłoś model
1 / 10
The Tri-monster claw backscratcher — zdjęcie 1
1 / 10

The Tri-monster claw backscratcher

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Attribution
SzczegółyWydruki i komentarzeRemiksyKolekcjePowiązane

Human hand-sized it is easy to reach all spots on your back and provide a larger scratch area for maximum satisfaction.

Pros: 

Large size3-sided
  • easy to reach everywhere on your back
     
  • great scratch satisfaction
     
  • can also be used without a stick
     
  • the monster claw doubles as Halloween decoration
  • different scratch types for different areas of your body depending on sensitivity
     
  • easy to also help scratch someone else or your pet

Note: This scratcher is intended to use without clothes covering the scratch area. It would be too big to fit inside your shirt.

 

Printing instuctions:

  • print in PLA (mine is in galaxy black)
  • 3 perimeters at 0.2-0.3mm layer height (I printed it at 0.3mm with 0.6mm nozzle)
  • print on the flat back on top of the spikes - use brim for adhesion
  • no supports needed
     

Designed with a 5.9mm diameter stick of approximately 32cm length. Feel free to adjust the hole to your stick size.

I recommend needle nose pliers to remove the brim - it looks like a lot, but is pretty quickly done. Depending on your preference, you can sand the spikes and or finger nails a little bit after.

Designed for the Scratchers contest.

 

Update: added click together handle ( tight fit; I used a vice to press securely in place)

Tagi

handmonsterclawcontestbackscratchernails