1 / 2
Dewalt Brad Point Bit Organzier v2--Now with MAGNETS! — zdjęcie 1
1 / 2

Dewalt Brad Point Bit Organzier v2--Now with MAGNETS!

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This organizer is to keep a DeWalt 6-Piece Brad Point Drill Bit Set from rolling around in my toolbox. Now with MAGNETS!

Ocena
0 / 5
Polubienia
4
Pobrania
30
Wydruki
0
Wyświetlenia
140
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution

This organizer is to keep a DeWalt 6-Piece Brad Point Drill Bit Set from rolling around in my toolbox.  This version has MAGNETS to retain each bit in place, with just enough strength so as to be easy to remove from the holder, yet allow the holder to be completely inverted without any of the bits (even the heaviest) from falling out.

It's setup for a single extruder 2-color print.

Designed in Autodesk Fusion 360.

Prusaslicer .3mf, Autodesk Fusion 360 Fusion Archive (*.f3d), and High Resolution STL included.

Print instructions

Category: Tool Holders & Boxes

Printed with 0.2mm layer height and 20% Cubic Infill on a Prusa I3 MK2.5 in Atomic Filament's Black PLA for labels and Matterhackers PRO Orange at default Prusaslicer Prusament PLA settings.  

NOTE: You'll also need 12, 3/8" (9mm) diameter x 1/8" (3 mm) thick, round Neodymium N52 magnets.  I used K&J Magnetics D62-N52, but any similarly sized N52 should work.  You MAY need to adjust the tolerances for the magnet holes in the .F3D as these are tight for my Prusa MK2.5 and MK3S.  I did also use a small dot of superglue in the bottom of each hole to retain the magnet during the remainder of the print.  If you modify the tolerance, look for the magnetClearance parameter in the User Parameters of the model.  Each cut is magnetDiameter + magnetClearance.

The .3mf File includes printer pauses at each of the 6 spots for magnet insertion, as well as for the color change.  NOTE:  There are 6 separate pauses as the magnets are located 3 layers below each bit and the bit depths are all different!  Consequently you'll need to babysit this print.  Also, I noticed that my MK2.5 did NOT beep when it was ready for the each pair of magnets.  Not sure if that's a firmware error or not.

The new version of the model is 20.4mm thick vs 16.2mm for the previous version, to make room for the magnets.

Tagi