Box case for HW-681 power converter Dual USB Charger board 3a (6-26v to 5v DC-DC)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This box allows you to protect the circuit in the HW-681 charging module.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 195
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This box allows you to protect the circuit in the HW-681 charging module.
The charging module allows (on my board, see details on others) an input range of 6-26v DC and has an output of 5v DC up to 3a between the two ports.
The design that I attached is pressure-fitted so it can be a bit tricky to disassemble it again without damaging any support embedded in the board.
I recommend soldering the cable first and tying a knot before placing it. In the box we have some holes for the cable output that allows you to tie a knot and avoid damage to the board if you pull the cable a little.
