Box case for HW-681 power converter Dual USB Charger board 3a (6-26v to 5v DC-DC)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This box allows you to protect the circuit in the HW-681 charging module.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 30
- Makes
- 0
- Views
- 191
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This box allows you to protect the circuit in the HW-681 charging module.
The charging module allows (on my board, see details on others) an input range of 6-26v DC and has an output of 5v DC up to 3a between the two ports.
The design that I attached is pressure-fitted so it can be a bit tricky to disassemble it again without damaging any support embedded in the board.
I recommend soldering the cable first and tying a knot before placing it. In the box we have some holes for the cable output that allows you to tie a knot and avoid damage to the board if you pull the cable a little.
