Inline Air Filter Housing for 6in Ductwork
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An inline air filter housing and tray insert for 6 inch ductwork.
- Ocena
- 0 / 5
- Polubienia
- 29
- Pobrania
- 89
- Wydruki
- 0
- Wyświetlenia
- 844
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
This is a print to add an inline filter to 6in ductwork. I used it for a fresh-air intake for a house, but it could be used for many air filtration needs!
For 6in diameter ductwork.
Neodymium magnets:
(12) 10x3mm cylinder
(4) 20x10x3mm rectangular
Uses LV-H132 replacement filters. (Filter not included, haha)
--
The filter fits into either side of the tray. As long as the magnets are consistently oriented, the tray insert into the shell is reversible.
While the magnets should fit into the slots, some may need glue due to minor size variations. I just super glued them all for safety.
The model edges are shaved to fit the print area of a standard Prusa MK3S.
--
*Model magnet holes slightly modified from the images. The two dead-center magnet channels on the shell and tray have been removed, as the print wall was too thin to accomodate the receiving magnets while remaining flush. With all magnets populated, the hold is still very firm.
--
Thanks for looking!